Book a demo

Energy monitoring and efficiency platform

Stop estimating leaks. Measure them.

Compressed air, chillers, generators and steam — one platform, minute-level resolution. Every improvement we recommend is verified against the bill.

Book a demo Solutions

Weekend compressed air leak Production stops on Friday evening and restarts on Monday morning. Compressed air flow, however, never falls to zero across the weekend — it settles at a low, steady level. The area between the two curves is the leak in the system.
Compressed air flow Production Leak schematic

The problem

An energy bill shows the total, never the reason.

On most sites the utilities run on a single meter, often unmeasured entirely. The figure that arrives at month end will not tell you what actually cost the money: a leak, a set pressure that is too high, a machine idling, or simply more production.

While that question stays open, efficiency spending rests on guesswork — and guesswork either stops the investment or aims it at the wrong place. We take the answer from measurement.

What we measure, from where, at what resolution

Every module runs on the same measurement layer. This is the raw data from the floor; everything else is built on top of it.

Measurement plate

Field reading
1 min
Analysers, transmitters, machine controllers · Modbus RTU/TCP
Site gateway
cellular
Panel-mounted · carries data over MQTT
Meter data
hourly kWh
Distribution operator · index and demand
Market data
per MWh
Day-ahead price and renewable levy
Outdoor air
°C · %RH
Hourly meteorology · by site location
Retention
90 days raw
Hourly and daily summaries kept indefinitely

Data stays on our own infrastructure. There is no dependency on equipment vendors’ cloud services, and if you remove the installation your history stays with you.

Solutions

Same data, different questions.

  1. 01

    Compressed Air and Compressor Monitoring

    What is compressed air actually costing us, and how much of it is leaking away?

  2. 02

    Chiller and Cooling System Monitoring

    How efficiently did the cooling plant actually run today?

Method

Measuring on its own is not enough.

Plenty of systems collect data from the floor. The difference lies in whether that data ever becomes a judgement. Without all four steps, monitoring is an expensive chart on a screen.

  1. 01

    Measure

    Power analysers, transmitters and machine controllers are read every minute. A site gateway carries the data to the platform — no extra PC or local server required.

  2. 02

    Derive

    A raw reading means little on its own. Specific energy, COP, leak rate and the expected invoice are all calculated at this layer.

  3. 03

    Compare

    Each derived value is held against a reference: the machine’s datasheet curve, the site’s own history, or the line items on the invoice that arrived. A number without a reference decides nothing.

  4. 04

    Alert and report

    When a deviation clears the threshold an alarm opens and an email goes out. Monthly reports are built on the same calculation — what you read in the report comes from the same source as what you see on screen.

Every figure is shown with its provenance: measured, derived or estimated. The three are never presented as equivalent.

Let us measure what is happening on your site.

In a one-hour call we look at your existing setup and set out exactly which measurement points are needed and what you would be able to see.

Book a demo